exceeded the allowable page request rate - Panda Crazy Script

Discussion in 'Help & Guides' started by Evelin, Sep 5, 2020.

  1. Evelin

    Evelin New Turker

    Messages:
    2
    Gender:
    Female
    Ratings:
    +1
    Good evening everyone,

    Today I started using the Panda Crazy Script, and after a few hours of using the error message shown in the image below.
    Does anyone know how to tell me how I can reduce the number of scripts running or adjust the settings of those scripts to decrease the number of times I get this message?
    I'm new to the script and I don't know much.

    I have the following problem when trying to open a hit (which I always do)
    upload_2020-9-5_20-18-23.png
     
  2. Gerbilreaper

    Gerbilreaper Active Turker

    Messages:
    748
    Gender:
    Male
    Ratings:
    +1,262
    I am by no means an expert in this matter, but here is the wiki page about Page Request Errors.

    https://forum.turkerview.com/wiki/page-request-error

    It mentions a few speed based limits to work with. I hope this helps you adjust your scripts to work better for you. :) With any luck someone more technical will come along and lend you a hand. I personally don't use Panda Crazy and when I used MTS I didn't have to mess with any of that to avoid PRE's.
     
  3. Evelin

    Evelin New Turker

    Messages:
    2
    Gender:
    Female
    Ratings:
    +1
    Thank you, it helped me a lot to solve the problem
     
    • Like Like x 1
    Last edited: Sep 7, 2020